There are a few reasons why your toilet may be rocking. One possible cause is a loose flange bolt. This bolt keeps the toilet level with the floor, and it’s often hidden behind decorative pieces. In order to fix the problem, you can wedge plastic shims underneath the base and tighten the flange.
Another possible reason for a rocking toilet is an uneven floor. This problem can be solved by leveling the floor under the toilet, which is much easier than replacing the floor. The rocking motion could also damage the seal on the wax ring. If that’s the case, you’ll need to replace the wax ring first.
A broken wax seal under the toilet may also be the cause of rocking. You can see if the wax ring has become loose by looking for discoloration around the base of the toilet. If you notice discoloration around the base of the toilet, you may need to scrape it up. After removing the old ring, replace it with a new one that is tight against the flange.
Plastic shims can be inserted into the gaps to help correct the rocking problem. These shims are typically available at home centers. If shims are not available, you can also try tightening the flange bolts. However, be careful when tightening the flange bolts as it may damage the porcelain toilet.
If you don’t know how to tighten the bolts, use an adjustable wrench. Be sure to tighten the bolts evenly and securely, so they don’t damage the porcelain. When tightening the bolts, use a level to make sure the toilet is level. If the bolts are too long, you can cut the extra length with a hacksaw.
Another problem that can cause rocking toilets is loose bolts holding the toilet seat in place. Loose bolts can be fixed by tightening them with a screwdriver. You may also need to check the base of the toilet to ensure that it’s not wobbling. Loose bolts will allow water to leak out of the toilet and onto the bathroom floor.
A rocking toilet is not only a nuisance but can be a health hazard. It can also cause leaks around the base of the toilet and cause a bad odor to fill the room. It’s important to know how to fix a rocking toilet so you can avoid hiring a plumber to fix the problem.
First, you need to remove the old flange from the base of the toilet. You can then replace it by putting the new one. To do this, make sure to use a putty knife to remove the wax seal. Then, install the new flange, making sure to put the bolts in at the three and nine o’clock positions on the rear wall of the toilet.
The most common reason for a wobbly toilet is loose flange bolts. The flange bolts join the toilet bowl to the floor and often loosen over time. Tightening these bolts will fix the wobbling problem. However, this will require removing the toilet bowl from the floor. The problem can also be caused by uneven floors or loose tile underneath.
